GuitarPCB.com

Guitar Pedal Projects. Top 5 in DIY With Forum Support!

Forums

Post Reply
Forum Home > Layout Gallery - GuitarPCB Build Documents, Mods and Tips > D'Lay Tap Tempo Board

Barry
Site Owner
Posts: 8793

Advanced build requires Tap Tempo Chipset from ToneGod's site.

Disclaimer: Project requires the Taptation Chip Set purchased separately in order to work. You can order the Chip Set by clicking on the link above.


This is an advanced build.

Support is limited to our circuit board & wiring only.

We cannot support the chipset for obvious reasons.

Dimension approximately 1.5" x 1.75"


Build Instructions


You need Adobe Flash Player to view this content.



You need Adobe Flash Player to view this content.





Purchase Link for Taptation Chip Set

Make sure the Chip is available first before buying the Board!

Disclosure: GuitarPCB is not responsible for availability of Chip Sets!

The TapTempo board works by using a Digital Potentiometer (MCP41100) that is controllable by either a Standard Pot (Time) or a Momentary Switch (S1) to set the Delay Time of a PT2399. The standard delay times range from 25ms to 1125ms.

The TapTempo Board replaces the “Time” Pot (as well as R22 and R9) on the D’LAY.

For more info please read the Discussion thread above and also read the Taptation Chip Set info.


Recommended accessories:

1. Barry's Famous Pot Condoms™ .

2. 3PDT Wiring Boards .

3. Barry's Best Pedal Hookup Wire.

4. DPDT Wiring Boards - Perfect for Mods

5. DC Power Jacks 2.1mm

6. Common Anode LED (Optional to Standard LED)

7. Plastic Bezels for Common Anode LEDs

February 27, 2018 at 4:23 PM Flag Quote & Reply

This topic is closed, no additional posts are allowed.