GuitarPCB.com
D.I.Y. - Guitar Pedal Projects
Dr Phybes Output Signal Add Video
Signal at pin 1 IC2 and at the output. Test signal 200mV 440 Hz
|
| 276 Views |
Post a Comment
Oops!
The words you entered did not match the given text. Please try again.
3 Comments
I wish every circuit was this interesting to watch.
By the way this is the easiest method of adjusting the trimmer for optimal performance. Connect chanel 1 of the oscilloscope to the input and channel 2 to the output of the phasing stage (pin1 IC2). Use a test frequency of a few hundred Hz (lower frequencies don't phase as much), adjust the trimmer until you get maximum horizontal travel of the wave on channel 2
By the way this is the easiest method of adjusting the trimmer for optimal performance. Connect chanel 1 of the oscilloscope to the input and channel 2 to the output of the phasing stage (pin1 IC2). Use a test frequency of a few hundred Hz (lower frequencies don't phase as much), adjust the trimmer until you get maximum horizontal travel of the wave on channel 2
Pretty cool, tonmann! Can we get a video like this for every circuit? :-)
Man, I could watch scope for hours..... It kind of sucks you in like a strobe tuner. I gotta get one.
Oops!
Oops, you forgot something.